Leuchtie Plus Easy Charge Operation Manual

LEUCHTIE

Activation process

Before using the LEUCHTIE for the first time please remove the transport protection (insulation cap).
It is located at the opposite side of the size sticker.
Separate the silicon tube from the battery
•
part by pulling them apart with a slight
angular movement (1).
In doing so, retain the silicon tube close to
•
the battery part.
Remove the red insulation cap (2).
•
Insert the tube straight into the battery part
•
and firmly press them together as far as it
can go.
The batteries need to be charged before
using the LEUCHTIE for the first time!
(see page 2).
In case you opened the battery part on both
sides, please keep in mind that you need to
reinsert the two poles correctly as seen in the
image to the right: with the charging contacts
facing up, the end of the tube marked with the
size sticker is inserted on the right. This side is
the negative pole and can be identified by the
blue ring inside the battery part. The left side is
the positive pole (red ring inside the battery
part). Insert the end of the tube without sticker
here.
Turning the LEUCHTIE on and off
Simply slip the LEUCHTIE over the dog's head
and it will turn on automatically thanks to a
sensor as soon as the battery part is facing
downwards. When the battery part faces
upwards the LEUCHTIE will turn off after
approximately one minute. Therefore, suspend
the LEUCHTIE e.g. on a hook for storage.
®
with USB charging station – directly rechargeable
Please read and observe the following safety instructions to
have as much pleasure in your new LEUCHTIE as possible.
Please keep this document in a safe place.
Page 1: Activation
Page 3: Troubleshooting
Plus Easy Charge
OFF
Page 2: Recharging the batteries
Page 4: Safety information
08/2016
ON