Rear Seats; Varioflex Rear Seats - Skoda Karoq 2019 Owner's Manual

32 Seats, steering wheel and mirror ›
Stop position change
›
With the ignition off and the driver's door open,
press any button on the seat to be adjusted.
Or:
›
Press the button on the key.
›
In other cases, release the held memory button.
Settings
Storing driver's seat and exterior mirror position
for driving forwards
The seat position can be stored if the angle of in-
clination of the seat back relative to the seat surface
is less than approximately 110° and the seat is not in
any of the end positions.
Storing front passenger´s exterior mirror position
for reversing
›
Turn on the ignition.
›
Activate the folding function of the mirror in the
Infotainment in the following menu.
Or:
›
Turn the exterior mirror knob to the position .
›
Engage reverse gear.
›
Adjust the mirror to the desired position.
›
Disengage reverse gear.
The set mirror position is saved.
When changing the stored seat and exterior mir-
ror position for forward driving, the passenger exte-
rior mirror position for reverse driving must be re-
stored.

Rear seats

Fold the seat backs forwards
Before folding down
›
Insert the rear headrests as far as they will go or
remove them.
Rear seats
›
Turn on the ignition.
›
Adjust the seat and the
exterior mirrors.
›
Press the button
A
and within 10 seconds
one of the memory
buttons .
B
Storing is confirmed by
an acoustic signal.
›
Adjust the position of the front seats in such a way
that they are not damaged by the folded-down
seat backrests.
›
Pull the outer seat belt to the side trim.
Folding forwards from the passenger compart-
ment
Folding forwards from the luggage compartment
Folding back up

VarioFlex rear seats

What you should be mindful of
Plugs and sockets under the seats
Depending on the equipment, plugs may be located
on the underside of the seats and sockets with
hinged protective plates may be located under the
seats.
›
Press the release han-
dle and fold the seat
forwards.
›
Pull on the lever.
The seat back is un-
locked and partly fol-
ded forwards.
›
Pull the outer seat belt
to the side trim.
›
Fold the seat backrest
back up.
The release handle must
audibly click into place.
›
Check that the seat
backrest has locked in
place. The pin must
A
not be visible.