Crystal Mountain STORM Bottom-Load Installation Instructions

Install pou water system

Install POU Water System

NOTES

Installation should only be executed by properly trained personnel. Check and comply with all national

and local regulations regarding mains water access. The connection must be to the potable mains water

supply and should be via a shut off valve. An appropriate anti-flood device should be fitted as closely as

possible to the mains connection point. In order to satisfy plumbing regulations, a backflow preventer or

check valve maybe required.

Failure to use an appropriate anti-flood device for any reason will not obligate or make Crystal Mountain

responsible in any way for Product Liability issues relating to any claims, including water damage claims.

INSTALLATION INSTRUCTIONS

Water inlet pressure:

• Minimum 20 PSI (0.138 MPa)

• Maximum 80 PSI (0.552 MPa)

• Where pressures exceed 80 PSI (0.552 MPa) a Pressure Reducing Valve must be fitted

a. Unpack:

1) Slide the access door upwards to open (Figure 4- 1).

2) Unstrap the Velcro belt, remove the POU Kit along with the 2 pcs foam pads and plastic bag (Figure

4- 2). (Discard: Strap, Foam Pads and Bag)

Figure 4-1

Figure 4-2

b. Rinse:

1) Slide up Reservoir Kit from its frame (Figure 4-3 and 4-4).

Figure 4-3

Figure 4-4

4 - 1

Table of Contents

Do you have a question about the STORM Bottom-Load and is the answer not in the manual?

Page 1 In order to satisfy plumbing regulations, a backflow preventer or check valve maybe required. Failure to use an appropriate anti-flood device for any reason will not obligate or make Crystal Mountain responsible in any way for Product Liability issues relating to any claims, including water damage claims.
Page 2 2） Use latex or nitrile gloves or wash hands before and after handling water contact parts. Remove cover assembly from the reservoir by pulling upwards (Figure 4-5 and Figure 4-6). Rinse cover assembly and reservoir with clean water and reassemble prior to installation into the frame assembly (Figure 4-7 and Figure 4-8).
Page 3 Figure 4-17 Figure 4-18 3. Install POU system into cooler: a. Connect the bottle tube (within cooler) to the top of the POU system (Figure 4-19 to 4-21). Figure 4-19 Figure 4-20 Figure 4-21 b . Verify Indicator Position Ensure that float indicator is in the GREEN position after installation is complete (Figure 4-22).
Page 4 c. Position POU system within the cooler, ensuring that the tubing is not kinked or located where it will interfere with the access door (Figure 4-23). Figure 4-23 d. Push downwards to close the access door (Figure 4-24) Figure 4-24 4.