HP A-F1000-E Getting Started Manual page 81

An ACSEI server can register multiple ACSEI clients.
ACSEI timers
An ACSEI server uses two timers, the clock synchronization timer and the monitoring timer.
The clock synchronization timer is used to periodically trigger the ACSEI server to send clock
•
synchronization advertisements to ACSEI clients. You can set this timer through command lines.
• The monitoring timer is used to periodically trigger the ACSEI server to send monitoring requests to
ACSEI clients. You can set this timer through command lines.
An ACSEI client starts two timers, the registration timer and the monitoring timer.
• The registration timer is used to periodically trigger the ACSEI client to multicast registration requests
(with the multicast MAC address being 010F-E200-0021). You cannot set this timer.
The monitoring timer is used to periodically trigger the ACSEI client to send monitoring requests to
•
the ACSEI server. You cannot set this timer.
ACSEI startup and running
ACSEI starts up and runs in the following procedures:
The firewall module runs the ACSEI client application to enable ACSEI client.
1.
Start up the network device and enable the ACSEI server function on it.
2.
The ACSEI client multicasts a registration request.
3.
After the ACSEI server receives a valid registration request, it negotiates parameters with the
4.
ACSEI client and establishes a connection with the client if the negotiation succeeds.
The ACSEI server and the ACSEI client mutually monitor the connection.
5.
Upon detecting the disconnection of the ACSEI client, the ACFP server removes the configuration
6.
and policies associated with the client.
Configuring ACSEI server on the network device
Follow these steps to configure the ACSEI server:
To do...
Enter system view
Enable ACSEI server
Enter ACSEI server view
Configure the clock
synchronization timer
Configure the monitoring timer
Close the specified ACSEI client
Restart the specified ACSEI client
Configuring ACSEI client on the firewall module
Follow these steps to configure the ACSEI client:
Use the command...
system-view
acsei server enable
acsei server
acsei timer clock-sync minutes
acsei timer monitor seconds
acsei client close client-id
acsei client reboot client-id
75
Remarks
—
Required
Disabled by default.
—
Optional
Five minutes by default.
Optional
Five seconds by default.
Optional
Supported on the ACSEI client
running Linux only
Optional