Husqvarna DMS 160 A Operator's Manual page 11

Drilling in the ceiling
1 Column screw and lock screw
2 Locking nut
3 Column screw and lock screw
• Place the stand in the required position.
• Check that the support column screw in the drill column is
screwed in. Fold up and lock the drill column in the vertical
position with the locking nut.
• Check that the drill bit is in the right position. Clamp the
telescopic support column against the ceiling with the
support column mechanism.
• Screw in the support column screw against the ceiling to
secure the drill column. Secure with a locking nut, 30 mm.
Use a wooden batten as packing.
• The expander attachment can be used to provide
additional anchorage of the drill column. (Available as an
accessory.) The attachment is adjusted against the
support column screw and is secured on the wall with an
expansion bolt. Secure with a locking nut, 30 mm.
WARNING! The vacuum plate must never be
!
used for ceiling drilling. Careless or
incorrect use can result in serious or fatal
injury to the operator or others.
ASSEMBLY
– 11
English