Firmware Update - Fujitsu CELVIN NAS QE807 Operating Manual

Firmware update

Firmware update

During the firmware update, the power and network connections must not be
disconnected. Never switch the NAS off during the firmware update.
If the system is running properly, then there is no need to update the firmware.
Before updating the system firmware, make sure the product model and firmware version
are correct. Follow the steps below to update firmware:
► Read the "Release Notes" for this firmware version on the website
"http://www.fujitsu.com/fts/support"
► Before updating the system firmware, back up all data stored on the hard disk to
avoid any data being lost during the system update.
► Open the administration interface and select Control Panel - Firmware Update - Firmware Update.
► Click on Browse... to select the new firmware to update the system.
► Select the corresponding IMG file and click on Update system to update the firmware.
The system update may take tens of seconds to several minutes to complete
depending on the network connection status. Please be patient. The system
will inform you when system update is completed.
72
to check if it is necessary to update the firmware.
Fujitsu