Parameter Error During Project Download; Fatal Error At Project Download - Siemens SINAMICS G120X Operating Instructions Manual

Warnings, faults and system messages
9.6 List of fault codes and alarm codes
Cause: A parameter has been changed that requires the parameters to be backed up and the Control Unit to be switched OFF and
ON again.
Remedy: - Save parameters (p0971).
- carry out a POWER ON (switch-off/switch-on) for the Control Unit.
F01042

Parameter error during project download

Reaction: OFF2 (NONE, OFF1, OFF3)
Acknowledge: IMMEDIATELY
Cause: An error was detected when downloading a project using the commissioning software (e.g. incorrect parameter value).
For the specified parameter, it was detected that dynamic limits were exceeded that may possibly depend on other
parameters.
Fault value (r0949, interpret hexadecimal):
ccbbaaaa hex
aaaa = Parameter
bb = Index
cc = fault cause
0: Parameter number illegal.
1: Parameter value cannot be changed.
2: Lower or upper value limit exceeded.
3: Sub-index incorrect.
4: No array, no sub-index.
5: Data type incorrect.
6: Setting not permitted (only resetting).
7: Descriptive element cannot be changed.
9: Descriptive data not available.
11: No master control.
15: No text array available.
17: Task cannot be executed due to operating state.
20: Illegal value.
21: Response too long.
22: Parameter address illegal.
23: Format illegal.
24: Number of values not consistent.
108: Unit unknown.
Additional values:
Only for internal Siemens troubleshooting.
Remedy: - enter the correct value in the specified parameter.
- identify the parameter that restricts the limits of the specified parameter.
F01043

Fatal error at project download

Reaction: OFF2 (OFF1, OFF3)
Acknowledge: IMMEDIATELY
978
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
SINAMICS G120X converter