List Of Existing Parameters 10 / List Avail Par 10; List Of Modified Parameters 1 / List Chang Par 1; List Of Modified Parameters 2 / List Chang Par 2 - Siemens SINAMICS G120X Operating Instructions Manual

Note
Modified parameters are displayed in indices 0 to 298. If an index contains the value 0, then the list ends here. In a long
list, index 299 contains the parameter number at which position the list continues.
This list consists solely of the following parameters:
r0980[0...299], r0981[0...299] ... r0989[0...299]
The parameters in this list are not displayed in the expert list of the commissioning software. However, they can be read
from a higher-level control system (e.g. PROFIBUS master).
r0989[0...299]

List of existing parameters 10 / List avail par 10

Access level: 4
Can be changed: -
Unit group: -
Min:
-
Description: Displays the parameters that exist for this drive.
Dependency: See also: r0980, r0981
Note
Modified parameters are displayed in indices 0 to 298. If an index contains the value 0, then the list ends here.
This list consists solely of the following parameters:
r0980[0...299], r0981[0...299] ... r0989[0...299]
The parameters in this list are not displayed in the expert list of the commissioning software. However, they can be read
from a higher-level control system (e.g. PROFIBUS master).
r0990[0...99]

List of modified parameters 1 / List chang par 1

Access level: 4
Can be changed: -
Unit group: -
Min:
-
Description: Displays those parameters with a value other than the factory setting for this drive.
Dependency: See also: r0991, r0999
Note
Modified parameters are displayed in indices 0 to 98. If an index contains the value 0, then the list ends here. In a long
list, index 99 contains the parameter number at which position the list continues.
This list consists solely of the following parameters:
r0990[0...99], r0991[0...99] ... r0999[0...99]
The parameters in this list are not displayed in the expert list of the commissioning software. However, they can be read
from a higher-level control system (e.g. PROFIBUS master).
r0991[0...99]

List of modified parameters 2 / List chang par 2

Access level: 4
Can be changed: -
Unit group: -
Min:
-
Description: Displays those parameters with a value other than the factory setting for this drive.
Dependency: See also: r0990, r0999
SINAMICS G120X converter
Operating Instructions, 06/2019, FW V1.01, A5E44751209B AC
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Calculated: -
Scaling: -
Unit selection: -
Max:
-
Parameters
7.2 Parameter list
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
-
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
-
Data type: Unsigned16
Dynamic index: -
Function diagram: -
Factory setting:
-
605