Boiler Malfunction Led; Tap Messages - Franke Minerva 4-in-1 Electronic Installation And User Manual

EN
CAUTION: During a fault, the function of the boiler is switched off.
5l

Boiler malfunction LED

LED colour LED action
Red 1 second on / 1 second off
Red 4 x 0.5 second on / 2 seconds off
Red/white 1 second red / 1 second white
Red/yellow 1 second red / 1 second yellow
Red/blue 1 second red / 1 second blue
Red/orange 1 second red / 1 second orange
Red/green 1 second red / 1 second green
*) Switch off the boiler and contact Franke.
10l
Boiler malfunction LED
LED colour LED action
Red Flashes 1x and 2 seconds off
Red Flashes 2x and 2 seconds off
Red Flashes 3x and 2 seconds off
Red Flashes 4x and 2 seconds off
Yellow Flashes 1x and 2 seconds off
Yellow Flashes 2x and 2 seconds off
Yellow Flashes 3x and 2 seconds off
*) Switch off the boiler and contact Franke.

Tap messages

LED colour LED action
Blue / red Alternately
Orange Pulsating/Heartbeat
Orange Continuous
Orange Continuous
Orange Blinking
Description
Hardware fault
Software fault
Hardware fault - sensor is defective
Boiled selection fault - wrong pcb
No water pressure
Maximum protection has tripped - boiler too hot (*)
Boiler is upside down or installed upright
Description
Hardware fault
Hardware fault - sensor is defective
Boiled selection fault - wrong pcb
Boiler is upside down or installed upright
Boiler dry - no water in the boiler
Maximum protection has tripped - boiler too hot (*)
Water filter cartridge is finished and must be replaced
immediately. Heating of the boiler is switched off
Function
Protection active, the
first water dispensed
can be hot.
Filter cartridge is
almost consumed
(90%)
Filter cartridge has
been used (100%)
must be replaced
immediately.
Filter cartridge has
been used (110%)
blockade of boiling and
filtered water
No valve has been
detected / a valve is
defective
– 34 –
Description
Press the selector knob twice briefly while flashing
to cancel the protection function or press and hold
selector knob (3 sec.) until the water starts to flow.
Filter cartridge is almost finished and must be
replaced shortly.
Filter cartridge is almost finished and must be
replaced shortly.
Filter cartridge is finished and must be
replaced immediately.
Check the cabling and or the valve.