Lubricating And Adjusting The Machine; Product Overview; Controls - Toro Greensmaster Flex 18 Installation Instructions Manual

7
Lubricating and Adjusting
the Machine
No Parts Required
Procedure
1. Lubricate the machine according to the
instructions in your Operator's Manual.
2. Fill the gearcase with oil according to the
instructions in your Operator's Manual.
3. Fill the engine crankcase with oil according to
the instructions in your Operator's Manual.
4. Adjust the engine speed to the following
specifications:
High idle (no load)
Low idle (no load)
3300 to 3500 rpm
1800 to 2000 rpm

Product Overview

1. Choke lever
2. Fuel-shutoff valve

Controls

Choke Control
The choke control is located on the side of the engine
(Figure 19); you use it to help start a cold engine
Note:
Do not start or run a warm engine with the
choke in the CLOSED position.
•
Move the choke lever all the way to the left
(away from starter handle) to set the choke to the
CLOSED position.
•
Move the choke lever all the way to the right
(toward starter handle) to set the choke to the
OPEN position.
Fuel-Shutoff Valve
The fuel-shut-off valve is located on the side of the
engine below the choke control
Note:
Close the fuel-shut-off valve when the machine
is not used for a few days, during transport to and
from the job site, or when the machine is parked
inside a building; refer to
Fuel-Shut-Off Valve (page
14
Figure 19
3. Recoil starter handle
(Figure 19).
Opening and Closing the
16).
g265059