Cereg, Eps Network Registration Status - Fibocom L860-GL At Command User Manual

Command
Reference 3GPP TS 27.007

9.1.7 +CEREG, EPS Network Registration status

The set command controls the presentation of an unsolicited result code +CEREG:<stat> when <n>=1
and there is a change in the MT's EPS network registration status, or code +CEREG:
<stat>[,<tac>,<ci>[,<AcT>]] when <n>=2 and there is a change of the network cell, code +CEREG:
<stat>[,<tac>[,<ci>[,<AcT>[,<reject type>[,<reject cause>]]]]] when <n>=3.
Note1:
If the EPS MT also supports circuit mode services and/or GPRS services, the +CREG command
and +CREG: result codes and/or the +CGREG command and +CGREG: result codes apply to
the registration status and location information for those services.
The read command returns the status of result code presentation and an integer <stat> which shows
whether the network has currently indicated the registration of the MT. Location information elements
<tac>, <ci> and <AcT>, if available, are returned only when <n>=2 and MT is registered in the network.
Test command returns the range of supported network registration mode (i.e. <n>).
Note:
This command is supported only in R8 protocol with LTE.
Command
Set [Function]
The Set command controls the presentation of an unsolicited result code "+CEREG: "
and the result of the Read operation.
[Syntax]
AT+CEREG=[<n>]
[Response/Action]
OK
Or
+CME ERROR: <err>
Read [Function]
[Syntax]
AT+CEREG?
Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual
Description
Description
Page 153 of 254