Advertisement
Quick Links
Shampoo
Bowls
8400 BACKWASH SHAMPOO BOWL
WITH MODEL 522 FIXTURE AND
603 BACKFLOW PREVENTER
INSTALLATION AND PLUMBING
NOTE: Read the instructions through before starting
to familiarize yourself with the components.
Any conformance with LOCAL CODES or
INSPECTIONS is the RESPONSIBILITY
OF THE PURCHASER.
1. Attach the fixture to the bowl according to
the instructions packed with the fixture.
ATTACH HOSE RECEIVER TO BOWL
(STEPS 2 thru 4).
2. To make hose receiver installation easier,
complete these steps to cut screw threads
in the mounting holes:
S
Take a mounting screw and drive it 2 or
3 turns into one hole.
DO NOT OVERTIGHTEN.
S
Remove the screw.
S
Repeat for all four (4) mounting holes.
MOUNTING
SCREW
DRIVE
SCREW
IN 2 OR 3
TURNS
PAGE 1 of 4
8400
3. Place the gasket
over the flange
on the bottom
of the hose
receiver.
4. Place the hose receiver and gasketin the bowl.
Install the Mounting Bracket on the bottom
side of the Bowl with four (4) embossed
corners facing upward, against the
bottom of the Bowl. Secure with four (4)
Screws.
DO NOT OVERTIGHTEN.
A wholly owned subsidiary of The Wella Corporation
One Belvedere Boulevard, Belvidere, Illinois 61008
Printed in U.S.A. E.C.O. 9162 4001148 Rev. 04-05
8400 BACKWASH
SHAMPOO BOWL
HOSE
RECEIVER
GASKET
EMBOSSED
CORNER
(UP)
MOUNTING
SCREW
Belvedere USA Corporation
Advertisement
Related Manuals for Belvedere 8400 BACKWASH SHAMPOO BOWL
Summary of Contents for Belvedere 8400 BACKWASH SHAMPOO BOWL
- Page 1 SCREW (UP) IN 2 OR 3 MOUNTING TURNS SCREW MOUNTING SCREW Belvedere USA Corporation A wholly owned subsidiary of The Wella Corporation One Belvedere Boulevard, Belvidere, Illinois 61008 PAGE 1 of 4 Printed in U.S.A. E.C.O. 9162 4001148 Rev. 04-05...
- Page 2 7. Place the strainer body in the opening, 5. Attach the backflow preventer to the fixture and press it into the plumber’s putty. tailpiece. Do not overtighten. Place the end of the spray hose with the brass connector through the hole in the hose receiver. Attach the Spray Hose connector to the backflow preventer.
- Page 3 TO INSTALL THE 8400 BOWL IN THE S54K-Q BACKWASH. REFER TO THE INSTALLATION INSTRUCTIONS PACKED WITH THE CABINET. TO MOUNT THE 8400 BOWL TO 12. Set the bowl onto the wall bracket. Have a helper hold the bowl in place. Fasten the bowl THE WALL (STEPS 10 THRU 12) to the bracket with two -20 bolts supplied.
- Page 4 ROUGH-IN PLUMBING SPECIFICATIONS. IMPORTANT NOTE: This shampoo bowl is designed to be used with the Belvedere SR04 and SR24 Siesta Backwash Shampoo Chairs. Use of other chairs is not recommended. For optimum comfort when the bowl is used with Siesta Backwash Chairs, install the bowl so the neckrest is at 34-3/4”...
Need help?
Do you have a question about the 8400 BACKWASH SHAMPOO BOWL and is the answer not in the manual?
Questions and answers