Table of Contents
Advertisement
Quick Links
R
10 Ton
Air Hydraulic Pump
Model 40611
ASSEMBLY and OPERATING INSTRUCTIONS
®
www.HarborFreight.com
Copyright
1999 by Harbor Freight Tools. All Rights Reserved.
No portion of this manual or any artwork contained herein may be reproduced
in any shape or form without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353
Advertisement
Table of Contents
Related Manuals for Harbor Freight Tools Central Hydraulics 40611
Summary of Contents for Harbor Freight Tools Central Hydraulics 40611
- Page 1 1999 by Harbor Freight Tools. All Rights Reserved. No portion of this manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. For technical questions and replacement parts, please call 1-800-444-3353...
- Page 2 SPECIFICATIONS Hydraulic Capacity: 10,000 PSI Air Operating Pressure: 70-140 PSI Hydraulic Outlet: 1/4” x 18 NPT (female) Air Inlet: 1/4” x 18 NPT (female) Dimensions: 14-5/8” L x 5” W x 7-1/2” H Weight: 26.7 LBS. SAVE THIS MANUAL You will need the manual for the safety warnings and cautions, assembly instructions, operating procedures, maintenance procedures, trouble shooting, parts list, and diagram.
- Page 3 When unpacking, check to make sure that all parts shown in the parts diagram are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual. Please note that the air hose and parts shown in Figure 2 are options which are sold separately.
- Page 4 SET UP & OPERATION Preparation prior to first time use: Before using your compressor for the first time, loosen the Nut (1), allowing any trapped air to escape. Then proceed to step 1 below to fill with oil. tep 1: Open the OIL FILL PLUG (61) and allow any air to escape.
- Page 5 Step 5: Remove the HYDRAULIC VALVE CAP (62) and install hydraulic hose (sold separately) in NUT (1) as shown in Figure 4. (62) Figure 4 — Installing the Hydraulic Hose Step 6: Connect the other end of the hydraulic hose to the desired hydraulic accessory. Step 7: Set the Air Compressor’s regulator at 70-140 PSI (depending upon the required hydraulic pressure).
- Page 6 Step 10: To stop the hydraulic pumping action, release pressure on the PEDAL. Do not press down on the front of the PEDAL yet. Step 11: To release the pressure in the Hydraulic Accessory, push forward on the PEDAL as shown in Figure 6.
- Page 7 PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.
- Page 8 PARTS DIAGRAM MODEL # 40611 10 TON AIR - HYDRAULIC PUMP REV 08/04 Page 8 SKU # 40611...
Need help?
Do you have a question about the Central Hydraulics 40611 and is the answer not in the manual?
Questions and answers