Advertisement
LENS
This camera can accommodate Video signal control and DC voltage drive auto-iris lens.
ELECTRONIC CONNECTIONS
T able.1 shows wiring scheme for the 4pin Auto iris connector.
CAUTION:
The output power for auto-iris lens is +9VDC and the maximum current capacity is 40mA.
When using an auto-iris lens requiring voltage and current other then specified, supply lens
power only from an external power supply.
2
1
4
3
MECHANICAL CONNECTION
Before mounting any lens onto this camera, check that the rear lens dimensions do not exceed
the following maximum length, otherwise CCD imager could be damaged. The camera is
shipped, ready to accept "CS" type lens. If standard "C"-mount lens are to be used, it is
necessary to install the "C-mount Adapter" ring first, then the lens.
En-7
PIN
VIDEO SIGNAL CONTROL
1
+9 VDC (40 mA max.)
+9 VDC (40 mA max.)
2
3
AI-Video
4
GND
Fig.2
X
CS = 0.2"(6mm)
C = 0.4"(10mm)
Table1
DC VOLTAGE CONTROL
"X"
LENS
Fig.3
Control coil (-)
Control coil (+)
Drive coil(+)
Drive coil(-)
Advertisement
