Crossfader Section; Master Section - Stanton Mixer Control Surface/Audio Interface SCS.1m User Manual

3.1.3

Crossfader Section

Figure 3.4
3.1.4

Master Section

Figure 3.5
There is also an L/R peak meter that responds to MIDI feedback and can be set to indicate output levels if your
software supports it.
The CROSSFADER is traditionally used to fade between songs playing in different
channels. (Figure 3.4)
You might also consider mapping the CROSSFADER to non-traditional
functionalities, like effects parameters, filters, or setting selections (like scrolling
through effects).
The Master Section controls various SCS.1m outputs. (Figure 3.5)
The ZONE knob is meant to be mapped to an Aux out, like a booth monitor or
effects send. This is a MIDI control and does not affect the Aux output on the rear
panel of the mixer. This MIDI control would need to be assigned to the volume
control in the host application for that output.
The MASTER out can be mapped to control master output.
The HEADPHONES knob should be mapped to control the output level for the
attached headphones.
CUE MIX can be mapped to control the cue/program ratio in your headphones.
9