Operation - Sharp SWD-77EH-BK Quick Start Manual

OPERATION

IMPORTANT
This unit is intended for water dispensing only. Do NOT use other liquids. Do
NOT use for other purposes. Warranty is void if used with any other liquids
such as coffee, tea, juices, beer or wine.
This dispenser has been designed to use water bottles with a 3, 5, or 5.2 gallon
capacity. Do NOT use alternative bottles.
Initial Set Up
Do NOT plug in until steps 1-2 are completed.
WARNING
Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Allow the unit to sit upright for 4 hours. Make sure unit is in the
off position.
2. This model uses a pump to deliver water from the bottle to the
reservoirs:
i. Clean the bottle cap and neck.
ii. Remove the entire plastic cap from bottle.
iii. Adjust the length of the probe by pulling the B portion of the
tube to its maximum extension. Insert the probe into the bottle
and push it down. The probe will self-adjust to its appropriate
length. See illustration on right.
iv. Push down the probe head until it is seated.
v. Insert the power cord into the wall outlet.
vi. At initial start-up, it will take about 3 minutes for the reservoirs to fill with water.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
the water cooler and the bottles.
Failure to do so can result in back or other injury.
9
A
B