Add_Rm_Client - Fujitsu LAN Console Installation, Configuration And Operation

Remote boot und installation
6.5.3

add_RM_client

Format 1:
add_RM_client -i IP_ADDR -e ETHER_ADDR [-g GATEWAY_ADDR]
-s SUBNETMASK -m MACRO -b BOOT_FILE CLIENT_NAME
A client for the BOOTP service is entered on the LAN Console with the
add_RM_client tool.
Options:
-i IP_ADDR
The IP address of the RM client that is going to be entered for remote
installation. This is specified in the usual Internet format: xxx.xxx.xxx.xxx
(decimal numbers separated by ".").
-e ETHER_ADDR
The Ethernet address (hardware/ MAC address of the LAN board con-
necting the RM to the Ethernet) of the RM client that is going to be
entered for remote installation. This is specified in the standard format:
x:x:x:x:x:x (hexadecimal numbers between 0 and ff separated by ":").
-g GATEWAY_ADDR
The IP address of the gateway to the subnet in which the RM client is
located. This parameter must be specified if the RM client is not in the
same subnet as the Solaris computer. It can be omitted if the two sys-
tems are in the same subnet. This is specified in the usual Internet for-
mat: xxx.xxx.xxx.xxx (decimal numbers separated by ".").
-s SUBNETMASK
The network mask of the subnet in which the RM client is located. This
is specified in the usual Internet format: xxx.xxx.xxx.xxx (decimal num-
bers separated by ".").
-m MACRO
Macro name which is entered in the /var/dhcp/dhcptab file (this macro is
referred to as the install macro from now on). The name can be freely
chosen. A separate name can be chosen for each client, but it is also
possible to use the same name for several clients. In this way, various RM
clients can be assigned to an installation class.
76
Configuration
U41224-J-Z916-1-76