Fit The Bark Control Collar - SportDOG SBC-10 Operating Manual

STEP :: 03

FIT THE BARK CONTROL COLLAR

IMPORTANT: The proper fit and placement of the Bark Control Collar is important for effective operation. The
Contact Points must have direct contact with your dog's skin.
See page 3 for Important Safety Information
To ensure a proper fit, follow these steps:
1. Make sure the unit is off.
2. With your dog standing (3A), center the unit so the Contact
Points are underneath your dog's neck, touching the skin
(3B). If your dog has a long or thick coat, you have two
options to ensure consistent contact: either trim the hair
around the Contact Points or switch to the longer Contact
Points included with your system.
Note: When switching to the longer Contact Points, ensure the o-rings are attached.
3. Check the tightness of the collar by inserting one finger between the end of a Contact Point and your dog's neck.
The fit should be snug but not constricting.
4. Allow your dog to wear the collar for several minutes and then recheck the fit. Check the fit again as your dog
becomes more comfortable wearing the Bark Control Collar.
Note: If desired, you may cut off the excess length of the collar strap after properly fitting the collar.
• You may need to trim the hair in the area of the Contact Points. Never shave the dog's neck; this may lead to a
rash or infection.
• You should not make the collar any tighter than is required for good contact. A collar that is too tight will
increase the risk of pressure necrosis in the contact area.
3A
SPORTDOG.COM
3B
9