Changing Modes - SportDOG SBC-10 Operating Manual

CHANGING MODES

Your SportDOG® Brand SBC-10 Bark Control Collar comes with 2 modes of operation and 1 test mode to check the
stim setting. The default mode for the SBC-10 is Progressive Correction. To change the mode follow these steps:
1. Make sure the unit is off.
2. Press and hold the On/Off button for 5 seconds until the Indicator Light begins to flash (no beep). Release to
enter mode selection.
3. Press the On/Off button within 5 seconds to cycle through the modes, indicated by the flashing light color.
PROGRESSIVE MODE: GREEN
USER-SELECT MODE: BLUE
Wait 5 seconds until the light flashes and beeps to indicate the current level. Then, continue to press the On/Off
button to choose the correction level. Example: Level 4 – light flashes and beeps 4 times.
TEST MODE: RED
After 5 seconds the unit will beep followed by a quick pulse of static stimulation
starting with a level 1 and increasing to 10.
Be careful not to touch the Contact Points so you will not receive a static
correction during this testing sequence. It is recommended that you use the
Test Light Tool to test the correction.
In Test mode the unit will turn off automatically after reaching level 10.
4. Once you are on the desired mode (level), wait 5 seconds and the unit will power off.
Once you turn the unit back on it will either flash green and beep once indicating Progressive mode or flash blue
and beep according to the level set indicating User-Select mode.
8 1-800-732-0144