Table of Contents
Advertisement
Replacing Front Wiper Blades
1 With the bonnet in closed state, and within 20 seconds
of switching the vehicle power system to the OFF
position, operate the wiper stalk switch by pressing
down and release, the wipers will enter the 'service
position' and stop on the windscreen.
2 Lift the wiper arm away from the windscreen.
MAINTENANCE
3 Press the retaining clips at both sides (as shown in
the figure), whilst pulling the wiper blade outward,
to remove the wiper blade from the wiper arm and
discard.
4 Position the fitting of the new wiper blade into the slot
of the wiper arm.
5 Push the wiper blade towards the wiper arm until it is
located embedded with a click been heard.
6 Place the wiper assembly back on the windscreen.
7 Operate the wiper stalk switch by pressing down again
and release, or set the vehicle power mode to ON,
the wiper will exit the service mode and automatically
return to its original position.
6
297
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ZS Series and is the answer not in the manual?
Questions and answers
Warning light like a cup with steam?????
The warning light that looks like a cup with steam on an MG ZS Series indicates a high motor temperature or a fault in the electric drive system. When this warning appears, it means the motor temperature is high, and although the warning message may disappear after a few seconds, the warning indicator will stay on. You should continue driving at a constant speed with a low load to cool the motor. If the vehicle cannot be driven or the issue persists, contact an MG Authorised Repairer immediately.
This answer is automatically generated