TANDBERG TT1220 Series Instruction Manual page 106

Alarm Categories and Conditions
Table D.6: Data Output Alarm Categories and Conditions
Alarm Category
Data output:
D.4 CA and PSI/SI Related Errors
D.4.1 CA Related Alarms
The CA status alarms indicate the current condition of the CA system
Table D.7: CA Related Alarm Categories and Conditions
Alarm Category
CA system:
D.4.2 PSI/SI Related Alarms
Contains information about the currently processed PSI/SI arriving at the
decoder.
Page D-6
Contents
Alarm Description
Error in Cannot decode the
stream component stream.
CC failure TS has missing packets on
the incoming transport
stream.
Buffer Output port rate is lower than
overflow incoming data rate.
Not used No PID selected to decode.
Same PID The selected PID is in use by
another part of the decoder.
Contents
Alarm Description
No access The DVB common interface
module has no access to the
currently selected
component.
No smart There is no smart card
card present in the card reader.
Bad SC The smart card present is
not valid.
Instruction Manual: Professional Receivers and Decoders (IRD)
Remedy Default
Make sure the A
correct component
is selected
Improve input W
signals, or check
source
Increase output rate A
or select new
component
Select PID or turn of A
data output
Choose a different W
PID.
Remedy Default
Check conditional W
access entitlements
with service
provider.
Insert the card. W
Insert a valid smart W
card.
ST.TM.TT1220.1