Pioneer CX-3250 Service Manual page 148

1
-
Removing the CC Monitor Unit (Fig.4)
A
Remove the two screws
1
and then remove the Holder and Cover.
Disconnect the FFC.
2
Remove the screw
3
and then remove the SD Unit.
Attention at assembly)
B
The connector lever is small and hard,
lock it surely.
Peeling the Tape.
Disconnect the Cord Assy using GGF1539.
4
Attention)
Remove Cord Assy from the connector on Keyboard PCB side.
It cannot be removed from BT Unit side.
C
Disconnect the four cables.
5
Remove the four screws
6
and then remove the CC Monitor Unit.
-
Removing the Keyboard PCB (Fig.5)
Remove the ten hooks.
D
1
and then remove the Holder.
When you remove the Holder from the Grille,
you can disassemble them easily by removing
the hook in the order shown below.
1.Remove three hooks on the right side on the rear face
2.Remove four hooks on the lower surface
3.Remove three hooks on the left side on the rear face
Remove the LCD Panel and Touch Panel.
E
(not shown)
Attention at assembly)
Lace FPC that connects
LCD Panel and CC Monitor Unit
into the hole of Holder.
Remove the Knob Unit.
2
Remove the two screws
3
and then remove the Keyboard PCB.
F
148
1
2
2
1
SD Unit
3
6
5
6
5
Attention at assembly)
Lace FFC that connects LCD Panel and
CC Monitor Unit into the hole of Holder.
Holder
1
1
1
1
AVIC-X930BT/XNUC
2
3
Attention at assembly)
When you attach Cord Assy,
fix it with tape so that Cord Assy
does not contact the edge of the plate.
Tape
Tape
Holder and Cover
5
5
CC Monitor Unit
1 1
Keyboard PCB
3
4
1
4
6
Fig.4
6
5
Knob Unit
1
2
1
3
1
3
1
Fig.5
4