Pioneer CX-3250 Service Manual page 14

1
A
a
AVIC-X930BT, AVIC-X9310BT :
Multi-control (Volume knob/
AVIC-F930BT :
Multi-control (Volume knob/
Rotate to adjust the AV (Audio and
Video) source volume.
Press the center of Multi-control to hear
the route guidance.
Press and hold the center of Multi-con-
trol to mute the AV (Audio and Video)
source. To cancel the muting, press and
hold it again.
B
b Front panel
c Detach button
Press to remove the front panel from the na-
vigation system.
For details, refer to Removing the front
panel on this page.
Protecting your product from theft
This function is available for AVIC-X930BT,
C AVIC-X9310BT and AVIC-F930BT.
The front panel can be detached from the navi-
gation system to discourage theft, as de-
scribed below.
CAUTION
Do not expose the front panel to excessive
shock or disassemble it.
Never grip the buttons tightly or use force
when removing or attaching.
Keep the front panel out of reach of small chil-
dren to prevent them from putting it in their
D
mouths.
After removing the front panel, keep it in a
safe place so it is not scratched or damaged.
Keep the front panel out of direct sunlight and
high temperatures.
When removing or attaching the front panel,
do so after turning the ignition switch off
(ACC OFF).
Removing the front panel
The navigation system cannot be operated
while the front panel is removed from the
E
navigation system.
F
14
1
2
1 Press and hold the Detach button, and
/MUTE)
slide it down.
/MUTE)
When you release your finger, the bottom of
the front panel separates slightly from the na-
vigation system.
2 Gently grip the bottom of the front
panel and slowly pull it outward.
Front panel
Attaching the front panel
1 Slide the front panel all the way into
the navigation system.
Make sure the front panel is securely con-
nected to the mounting hooks of the naviga-
tion system.
2 Push the lower part of the front panel
until you hear a click.
If you fail to successfully attach the front panel
to the navigation system, try again but be care-
ful not to force it as the panel could be
damaged.
Fastening the front panel
If you do not plan to remove the front panel,
the front panel can be fastened with supplied
screw.
Screw : BPZ20P040FTC (2mm×4mm)(UC)
AVIC-X930BT/XNUC
2
3
3
4
4