Table of Contents
Advertisement
•
The brakes of the tow traction unit must have
the capacity to stop the machine with machine
fully loaded and traveling at the maximum
recommended transport speed.
•
The power take-off drive of the machine requires a
traction unit with operating speeds of 540 rpm and
output power of 32 hp or higher. Do not exceed
the 540 rpm speed.
•
The machine must comply with local road
requirements if transported on public roads. A
slow-moving vehicle sign has been provided.
Signal lights and brakes are not provided and may
be required in some areas.
Hydraulic Fluid
Specifications
The reservoir is filled at the factory with approximately
38 L (10 US gallons) of high-quality hydraulic fluid.
Check the level of the hydraulic fluid before you first
start the engine and daily thereafter; refer to
the Hydraulic Fluid (page
Recommended replacement fluid: Toro PX
Extended Life Hydraulic Fluid; available in 19 L (5 US
gallon) pails or 208 L (55 US gallon) drums.
Note:
A machine using the recommended
replacement fluid requires less frequent fluid and filter
changes; refer to
Servicing the Hydraulic Fluid and
Filter (page
18).
Alternative fluids: If Toro PX Extended Life
Hydraulic Fluid is not available, you may use another
conventional, petroleum-based hydraulic fluid having
specifications that fall within the listed range for all the
following material properties and that it meets industry
standards. Do not use synthetic fluid. Consult with
your lubricant distributor to identify a satisfactory
product.
Note:
Toro does not assume responsibility for
damage caused by improper substitutions, so use
products only from reputable manufacturers who will
stand behind their recommendation.
High Viscosity Index/Low Pour Point
Anti-wear Hydraulic Fluid, ISO VG 46
Material Properties:
Viscosity, ASTM D445
Viscosity Index ASTM D2270
Pour Point, ASTM D97
Industry Specifications:
Note:
Many hydraulic fluids are almost colorless,
making it difficult to spot leaks. A red dye additive for
the hydraulic fluid is available in 20 ml (0.67 fl oz)
bottles. A bottle is sufficient for 15 to 22 L (4 to 6 US
gallons) of hydraulic fluid. Order Part No. 44-2500
from your authorized Toro distributor.
10
Checking
11).
cSt @ 40°C 44 to 48
140 or higher
-34°F to -49°F
Eaton Vickers 694 (I-286-S,
M-2950-S/35VQ25 or
M-2952-S)
Advertisement
Table of Contents
