Related Manuals for CPS Leak-Seeker 1
Summary of Contents for CPS Leak-Seeker 1
- Page 1 Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 TestEquipmentDepot.com ® Leak-Seeker Refrigerant Leak Detector &CE US Patent 8,555,701 OPERATION MANUAL...
-
Page 2: Table Of Contents
GENERAL INFORMATION Table of Contents General Information Introduction Leak-Seeker I Specifications ® Leak-Seeker I Overview ® Operation Modes of Operation Using the Leak-Seeker ® Leak Searching Tips Maintenance Sensor Replacement Diagram Warranty Introduction Flexible metal probe: 15" (380mm) long, .25" (6.4mm) diameter High output alarm speaker... -
Page 3: General Information
GENERAL INFORMATION Leak-Seeker I Specifications ® Sensor: State of the art E_MOS technology ® Gases: Detects refrigerants including those with hydrocarbon components (CFC, CH2F2, HCFC, HFC, HFO, NH3, HC. Hydrogen trace gas in 95% N2, 5% H2 mixture A2L refrigerants). CAUTION: This leak detector is not intrinsically safe. -
Page 4: General Information
Leak-Seeker I Overview ® Combining outstanding ease of use and the sophisticated leak sensing E_MOS technology exclusive to CPS Products, the ® Leak-Seeker I opens a new era in electronic leak detection. ® Advanced software algorithms control the operation of this in-... -
Page 5: Operation
OPERATION Modes of Operation Progressive Alarm Mode: The audible alarm increases in pitch as the concentration of re- frigerant gas seen by the sensor increases. The number of lit LED's in the bar graph indicator increases with the refrigerant concentration. Three blue LED's indicate the current setting. Large Leak Setting (L): Alarm begins to indicate at about 0.5 oz / year (14 g / yr.) depending on the refrigerant. -
Page 6: Using The Leak-Seeker ® I
OPERATION Using the Leak-Seeker ® SMART-BUTTON Operation: • Press the START button to turn the instrument ON. • While in any mode, press and hold the START button for three seconds to turn the instrument OFF. • Press and hold the START button to change sensitivity settings. - Page 7 OPERATION Leak Searching Tips 1. Take care not to plug the sensor housing tip by dragging it over dirty or wet surfaces. If the area is particularly dirty, or condensate (moisture) is present, it should be wiped off with a dry shop towel. No cleaners or solvents should be used, since the detector may be sensitive to their ingredients.
-
Page 10: Warranty
All products being returned for warranty repair must be accompanied by an original bill of sale and customer contact information. CPS Products, Inc. Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176...
Need help?
Do you have a question about the Leak-Seeker 1 and is the answer not in the manual?
Questions and answers