Honda XR150 2018 Owner's Manual page 86

Tyre Puncture Removing Wheels
u
Installation
Attach the side collar to the rear wheel.
1.
Place the rear wheel between the
2.
swingarm and install the drive chain over
the driven sprocket.
Make sure that the lug on the swingarm is
3.
located in the slot of the brake panel.
Brake panel
82
Slot
Lug
Swingarm
Rear axle nut
Insert the rear axle shaft from the left side,
4.
through the left swingarm, wheel hub,
brake panel and right swingarm.
Temporarily tighten the rear axle nut.
5.
Connect the brake rod to the brake arm.
6.
Adjust the drive chain slack.
7.
Adjust the rear brake pedal freeplay.
8.
Tighten the rear axle nut.
9.
Torque: 93 N·m (9.5 kgf·m, 69 lbf·ft)
After installing the wheel, apply the brake
10.
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
P. 65
2
P. 59
2