Husqvarna QCE7250W User Manual page 5

• Before mounting the appliance, check
if the oven door opens without
restraint.
• The appliance is equipped with an
electric cooling system. It must be
operated with the electric power
supply.
• The built-in unit must meet the
stability requirements of DIN 68930.
Cabinet minimum
height (Cabinet un-
der the worktop mini-
mum height)
Cabinet width
Cabinet depth
Height of the front of
the appliance
Height of the back of
the appliance
Width of the front of
the appliance
Width of the back of
the appliance
Depth of the appli-
ance
Built in depth of the
appliance
Depth with open
door
Ventilation opening
minimum size. Open-
ing placed on the
bottom rear side
Mains supply cable
length. Cable is
placed in the right
corner of the back
side
Mounting screws
2.2 Electrical connection
• All electrical connections should be
• The appliance must be earthed.
• Make sure that the parameters on the
600 (600) mm
• Always use a correctly installed
• Do not use multi-plug adapters and
550 mm
• Make sure not to cause damage to
605 (580) mm
594 mm
576 mm
• Do not let mains cables touch or
549 mm
• The shock protection of live and
548 mm
567 mm
• Connect the mains plug to the mains
546 mm
• If the mains socket is loose, do not
1017 mm
• Do not pull the mains cable to
550 x 20 mm
• Use only correct isolation devices: line
1500 mm
• The electrical installation must have
4 x 12 mm
• Fully close the appliance door before
• This appliance is supplied with a main
WARNING!
Risk of fire and electric
shock.
made by a qualified electrician.
rating plate are compatible with the
electrical ratings of the mains power
supply.
shockproof socket.
extension cables.
the mains plug and to the mains
cable. Should the mains cable need
to be replaced, this must be carried
out by our Authorised Service Centre.
come near the appliance door or the
niche below the appliance, especially
when it operates or the door is hot.
insulated parts must be fastened in
such a way that it cannot be removed
without tools.
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
connect the mains plug.
disconnect the appliance. Always pull
the mains plug.
protecting cut-outs, fuses (screw type
fuses removed from the holder), earth
leakage trips and contactors.
an isolation device which lets you
disconnect the appliance from the
mains at all poles. The isolation
device must have a contact opening
width of minimum 3 mm.
you connect the mains plug to the
mains socket.
plug and a main cable.
ENGLISH 5