Page 1
Quadcopter (4) AAA Batteries Spare Blades (2 black, 2 color) Controller Screwdriver Dromida Hovershot Quadcopter Flight Battery USB Charger Memory Card TO PREVENT MOTOR DAMAGE ALWAYS BE SURE THE THROTTLE IS OFF WHEN THE BLADES ARE OBSTRUCTED OR CONTROL IS LOST.
INSTALL BATTERIES IN THE CONTROLLER HOW to FLY Remove the screw and slide the cover down to insert the included 4 AAA batteries. CHARGING Plug charger into USB port or AC adapter (DIDP1125 not included) as shown and connect the battery. The red LED will flash slowly while the battery is charging.
MOTOR OVERLOAD PROTECTION may take several seconds for the DroneView network to appear in the The Dromida Hovershot is equipped with motor overload protection available network list in proximity circuitry that shuts down the motors in the event the propellers to your device.
When you have c o n f i r m e d t h a t files ha ve been successfully transferred to your device’s camera roll, press Select and choose the files you wish to delete if you no longer want them in the file gallery.
PROBLEM: Stabilization not working properly. CALIBRATION SOLUTION: (1) Battery voltage low. (2) Re-link. (3) Recalibrate the sensors. If the quadcopter is constantly drifting in the same direction or the quad is not PROBLEM: Will not take off. maintaining altitude, or any time a new fl ight control board has been installed, SOLUTION: Rotor blades incorrectly installed.
90-DAY LIMITED WARRANTY BATTERY PRECAUTIONS PLEASE DO NOT RETURN YOUR PRODUCT TO THE STORE. Dromida will The Hovershot uses a lithium polymer (LiPo) battery. Follow these repair or replace factory defects for 90 days from the date of purchase. This warranty specifi cally does not cover crash damage, misuse or abuse.
Reorient or relocate the receiving antenna. DECLARATION OF CONFORMITY: Increase the separation between the equipment and receiver. Product: Dromida 2.4GHz 4-Channel Tx Rx FCC ID: IYFMR101 Connect the equipment into an outlet on a circuit different from that to which the Item number: DIDJ1106 MR101 receiver is connected.
Need help?
Do you have a question about the Hover Shot and is the answer not in the manual?
Questions and answers