Related Manuals for primatech Q180
Summary of Contents for primatech Q180
-
Page 1: Operating Instructions
PNEUMATIC FLOORING STAPLER Q180 OPERATING INSTRUCTIONS WARNING Read these instructions thoroughly before using this tool and keep it handy for reference. Rev. 05/19 Printed in Taiwan... - Page 2 PRIMATECH PNEUMATIC 18 STAPLER The pneumatic flooring stapler Q180 is a professional precision tool specially developed for the installation of most of 3/8" to 5/8" solid and engineered hardwood flooring. Weighting only 3 lbs (1.4 kg), this specially designed tool makes the installation of thin or laminate flooring very easy.
- Page 3 CONNECTION & AIR SUPPLY SYSTEM To ensure maximum performance and efficiency, and also a minimum of care, this P RIMATECH pneumatic stapler requires clean, dry air. It is necessary to use a filter and a pressure regulator. This tool needs a detachable male coupler with 1/4" NPT male treads. The use of a 1/4" (1 cm) diameter air supply hose is recommended.
- Page 4 OPERATION Unload tool and rest it onto the subflooring, Connect the hose and cycle tool once or twice without fastener. After loading the tool, the tool is ready for use. With the flooring firmly in place, position the tool onto the flooring. Apply downward pressure to ensure that the safety contact is fully depressed and proper seating of the fastener.
- Page 5 YOU ARE USING THE RIGHT FASTENER AND THAT THE TOOL IS PROPERLY ADJUSTED PREVENTIVE MAINTENANCE This tool requires frequent lubrication. Use only detergent-free oil such as Primatech P-090. Few drops of oil daily in the air inlet is sufficient. Other types of lubricant may degrade the seals.
- Page 6 TROUBLESHOOTING This section will help to diagnose common problems and will give suggestions to solve them. Consult our on-line Technical Support site at www.primatech.ca/support for updated documents and more tips. , ALWAYS DISCONNECT THE AIR SUPPLY HOSE O PREVENT INJURY...
- Page 7 Make sure the magazine latch is engaged. b) Check the gate/foot assembly for damages or wear. c) Check the front end of the magazine for burrs or damages. THER PROBLEMS Contact Primatech: 1 (800) 363-1962 1 (418) 522-7744 by email support@primatech.ca...
Need help?
Do you have a question about the Q180 and is the answer not in the manual?
Questions and answers