Related Manuals for Roma Medical Reno Elite P325
Summary of Contents for Roma Medical Reno Elite P325
- Page 1 Reno Elite User Manual Model - P325 - Please ensure that this user manual is read and understood before using the powerchair. KB&S18072...
-
Page 2: Table Of Contents
Contents Maintenance Introduction Battery charger Intended Use Cleaning Technical Specifications Routine maintenance Feature Guide Circuit breaker Safety Advice Adjustments & Battery Removal Checklist Joystick depth Joystick Error Codes Further Information Footplate height Solar energy Seat swivel Health factors Arm width General use Flip-up arm rest &... -
Page 3: Introduction
Introduction Congratulations on your purchase of the Roma Reno Elite powerchair. This powerchair incorporates the latest innovative designs. The Roma Reno Elite can be used in confined spaces both indoors and out. The powerchair can be easily dismantled without tools. This allows the Reno Elite to stored in the boot of a vehicle or stored neatly in an indoor location The detachable battery pack allows convenient charging wherever necessary. -
Page 4: Feature Guide
Feature guide ‘Reno Elite’ Programmable joystick controller Flip up, width adjustable armrests Padded seat and fold down backrest Removable battery pack Rear anti-tippers Puncture proof non-marking wheels Flip up and depth adjustable footplate Handy storage basket... -
Page 5: Safety Advice
Safety advice • Read this manual carefully before using your powerchair. • Turn the power off when transferring to and from the powerchair. • Select a slow speed when going down gradients (max 6°) or over uneven ground. • Keep your feet on the powerchair whilst driving. •... -
Page 6: Adjustments & Battery Removal
Adjustments and battery removal Joystick depth adjustment It is possible to adjust the depth of the joystick controller for added comfort. Simply loosen the hand knob and slide the joystick to the required distance and fully re-tighten the hand knob. Footplate height adjustment The height of the footplate can be adjusted by fully undoing the two fixing bolts. -
Page 7: Seat Swivel
Seat swivel & removal The seat can be swivelled around the base unit. Lift up on the lever on the right side of the seat and rotate as necessary. To remove the seat fold down the backrest, lift up the lever and gently pull the seat upwards away from the chair at the same time. -
Page 8: Flip-Up Arm Rest & Angle Adjustment
Flip up armrests and angle adjustment The armrests flip up to allow for easier transfers. Simply lift the armrest when transferring. The angle of the armrest can be adjusted by undoing the locking nut and setting at the desired height. The nut should then be tightened to lock the adjustment in place. -
Page 9: Vr2 Joystick Controller
VR2 Joystick Controller Battery gauge This is an 8-segment display, which indicates if the joystick is switched on, gives the state of charge on the battery. Also, any faults in your power chair’s electrical system are also indi- cated by this display. Refer to page 16 for details. -
Page 10: Brake Release / Freewheel Operation
Joystick ‘Lock’ function Your controller is equipped with a lock function to prevent any unauthorised use. To lock the controller turn the power on and; • Press and hold the power button until the system bleeps. To unlock the controller: •... -
Page 11: Starting To Drive
Starting to drive your Powerchair Getting Started Select an area with plenty of space. Ensure that when seated in the in the powerchair you are in a comfortable position and can easily and freely operate the controls. Moving off and steering Turn the power on and check that your battery is fully charged. -
Page 12: Reaching And Stretching
Reaching and stretching Care must be taken when reaching and stretching for objects as this may affect the stability of the powerchair. When attempting to reach for objects it is very important that the power is OFF. Do not attempt to reach for objects on the floor by leaning forward or reaching between your knees. - Page 13 Warning: We advise caution when disassembling and lifting items. You must ensure that the person undertaking the action is able to safely and correctly handle the weight to avoid any personal injury. Ensure that the power is switched off and the joystick cable is disconnected before dismantling.
- Page 14 To reassemble, locate the pivot pin of the front chassis into the receiving slots of the rear chassis (each side) and lower to the bottom location. Caution: Please take care not to trap the joystick cable between the two parts Fully located in the bottom position...
- Page 15 Push down on the rear part of the frame as shown below. This will reconnect the two parts of the frame together. You will hear the latch ‘click’ into place. Caution: Always check that both parts are fully connected before refitting the seat and battery box.
-
Page 16: Battery Charger
Battery and Battery Charger Caution: The joystick controller should be switched off when charging Battery Charger The battery charger is a 2 amp switch mode type off board. The battery charging port is located on the underside of the joystick controller. There is also a charging port on the battery pack. This special feature allows the battery to be charged independently of the main powerchair. -
Page 17: Battery Pack
Battery Pack The Reno has a 22Ah AGM (2 x 12v) battery pack which has the advantage of being removable for charging off board. Caution: Do not open the battery pack. Always seek the advice of your mobility retailer should fuses or batteries need replacing. -
Page 18: Maintenance
Maintenance Battery Charger Your powerchair has been designed to provide the user with a long, reliable life provided it is correctly maintained and regularly serviced by an authorised dealer. However, due to inevitable wear and tear and technological improvements it is recommended that the average useable life of this powerchair is five years. -
Page 19: Checklist
Check list If your powerchair fails to operate, please check the following: • The unit is switched on. • All plugs and connections are firmly fixed. • Battery level shows full charge. • Free wheeling device is in the drive position. •... -
Page 20: Further Information
Further information Safety Information Regarding Electromagnetic Interference (EMI) Powerchairs and powerchairs are designed to operate under certain conditions. However, radio waves or electromagnetic fields may affect the operation of the powerchair. The source of EMI could be radio or television transmitters or portable devices such as mobile phones, portable CB radios etc. -
Page 21: Lap Belt Adjustment
Driving in Pedestrian Areas As mentioned previously, when using the powerchair in pedestrian areas always lower your maximum speed to that of the pedestrians around you. Remember the stopping distance of your powerchair and always allow enough space to stop safely to avoid collisions with pedestrians or other objects. Lap Belt Adjustment Ensure that you are sitting back fully into the seat with the pelvis as upright as possible and not leaning to one side. -
Page 22: Warranty Terms And Conditions
Warranty Terms and Conditions This is to certify that your Roma Medical product is warranted for a period of 12 months from the date of original purchase. This warranty is not transferable. Should a defect or operating fault arise within this period the Dealer from where the product was originally purchased should be notified immediately. -
Page 23: Notes
Notes... - Page 24 York Road Bridgend Industrial Estate Bridgend CF31 3TB United Kingdom Telephone: 01656 674488 Facsimile: 01656 674499 Email: sales@romamedical.co.uk Web: www.romamedical.co.uk...
Need help?
Do you have a question about the Reno Elite P325 and is the answer not in the manual?
Questions and answers