Set Up Material; Ctp User Interface; Testing - HEIDELBERG Suprasetter A106 Installation Manual

Set up material

Set up material using the Material Wizard (length, width, thickness).

CTP User Interface

Fig. 76 CTP User Interface Log File
8-up
PID 26910
Tab. PID plate edge sensor

Testing

Following installation, you must run the programs of the Material and System Wizard in the CTP User
Interface.
The Online Help for the Suprasetter user interface provides detailed instructions on how to do this.
The
Instructions for Testing
Suprasetter A106 – Installation
4-up
PID 26911
chapter provides in-depth information about how to test printing plates.
Start CTP User Interface and load a plate. Check
the entry for the plate edge sensor in the log file:
SOP: MisAlignment in μm: xxxx.xx (Fig. 76/1)
When the displayed value exceeds the absolute
value of 500 μm you must correct it by subtracting
this value from the PID value for the plate edge
sensor and saving the result as a new value in the
Parameter Editor.
Example:
MisAlignment = -750
PID 26910 old = 935000
PID 26910 new = 935000 - (-750) = 935750
Installation
79