4 Disassembly/Reassembly
There are no boards available individually as replacement parts. In the case of a defective receiver board or
MIF board, a repair is effected by exchanging the whole base station assembly (unit exchange).
All part numbers of spare parts are listed in Chapter 5.
Tools Required
When replacing the front cover, do not over-torque the screws. Excessive torque may damage the plastic
CAUTION
screw mountings.
You need the following tools:
Removing the Top Cover Assembly
Carefully place the base station upside down. To avoid scratches, place the unit on some cloth or other
1
soft surface.
Remove the six screws securing the top cover assembly to the chassis, using a T-10 Torx driver.
2
Holding both top cover and chassis assemblies together, place the base station upright again.
3
28
To Purchase, Visit
Avobus.com
•Torx-head screwdriver, size T-10
or
•Torx bit, for suitable driver, size T-10
or call
1-800-674-3655
Removing the Top Cover Assembly
Screw locations