Jumper T16 Instruction Manual page 64

Pressing the ENT key while the mixing source is active will display the submenu of the
source by category. Scroll up/down to the desired category and press the ENT key. It takes you
back to the parameter being edited on the first item in the selected category. Then you can
scroll up/down from there and press ENT to select the source.
Checkbox: Enable/disable this line.
Volume: The selected source will adjust the volume. A simple app will use the knob to
control the volume. Check the box to enable or disable this line.
SetFailsafe Int.Module: Allows dynamic setting of runaway protection on the ground or in
the air. Set the control interface to runaway protection and press the selected switch to store
the runaway protection value. This feature is available for internal XJT modules. The checkbox
enables or disables this line.
SetFailsafe Ext.Module: As mentioned above, but for the external module of the emitter.
The checkbox enables or disables this line.
Play Sound: Any simple sounds listed in the drop-down parameter box will be played.
!1x: Play the sound once, not at startup.
1x: Play a sound once.
1s-60s: Repeats the sound at the specified interval.
Play Track: Play any .wav sound file stored on the SD card. The list of available sounds will
be displayed in the parameter column of the drop-down box.
!1x: Play the sound once, not at startup.
1x: Play a sound once.
1s-60s: Repeats the sound at specified intervals.
Play Value: Say the value of any controls available in the parameter menu. These can
include switch or joystick values, or telemetry values or time.
62