Battery Replacement - Hunter Douglas PowerView Pebble Product Information Manual

baTTery rePlaCeMenT

Replacing batteries in the PowerView Pebble
will not cause the loss of any shade programming,
including Groups and Favourites.
The PowerView Pebble Remote uses two CR 2032
batteries.
q
Using any finger, gently LIFT and REMOVE the
PowerView Remote Module from the PowerView
Pebble.
w
ROTATE the back cover of the PowerView Remote
Module CLOCKwISE to open.
e REMOVE the back cover from the PowerView
Remote Module.
r
Using a finger or a small screwdriver, gently LIFT
and REMOVE the old batteries.
t
INSERT new batteries, making sure each is snug.
y REPLACE the back cover onto the backside of the
PowerView Remote Module.
NOTE: Align the notches on the inside of the
back cover to secure the batteries in place (See
image 6). Position the Open/Close locking feature
at the bottom of the PowerView Remote Module.
u
ROTATE the back cover COuNTER-CLOCKwISE
to close the back cover in place.
i Gently RE-INSERT the PowerView Remote
Module into the PowerView Pebble until it is snug.
NOTE: Indicator lights on the PowerView Pebble
Remote will illuminate, indicating there is power.
BATTERY LIFE OF REMOTE MODuLE IS LESS
o
THAN EXPECTED.
When the Pebble Remote Control is picked up, the
Remote Module's motion back lights are activated.
In situations where the remote control is under
constant movement, the motion back lighting can
activate more than normal causing the batteries to
deplete at a faster rate.
It is possible to disable the motion back light
function by pressing and holding the 6 channel
button for 6 seconds.
To re-enable motion back light press and hold the 6
channel button for 6 seconds.
Remote
®
q
e r
y
i
4
– 21 –
w
t
u
VIDEO INSTRUCTION