Axxess ASWC-1 Instructions

Axxess ASWC-1 Instructions

Connections
Hide thumbs Also See for ASWC-1:

Advertisement

Congratulations, your vehicle will be auto-detected by the
ASWC-1.

ASWC-1 Connections

1) Connect the Black wire of the ASWC-1 to chassis ground.
2) Connect the Red wire of the ASWC-1 to a 12-volt accessory wire, one that turns on
and off with the ignition key.
3) Connect the Green/Orange wire of the ASWC-1 to pin 7 of the vehicle. Below is a
picture of what the connector in the vehicle looks like:
This is the pin view of the connector in the vehicle
4) Connect the Black/Green wire of the ASWC-1 to pin 8 of the vehicle.
5) Connect pin 6 of the vehicles harness to chassis ground. You may use the same chassis
ground as the black wire.
6) All other wires on the ASWC-1 please tape up, they will not be used.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ASWC-1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Axxess ASWC-1

  • Page 1 ASWC-1 Connections 1) Connect the Black wire of the ASWC-1 to chassis ground. 2) Connect the Red wire of the ASWC-1 to a 12-volt accessory wire, one that turns on and off with the ignition key. 3) Connect the Green/Orange wire of the ASWC-1 to pin 7 of the vehicle. Below is a...
  • Page 2 4 pin end into the corresponding SWC plug on the radio. * For XITE radios: Connect the steering wheel control SWC-2 wire to the BROWN wire of the ASWC-1. Isolate and tape up the Brown/White wire, it will not be used.
  • Page 3 6) The led will pause for another 2 seconds then flash Red up to 15 times. 7) This is the end of the auto-detection stage. If the ASWC-1 detected the vehicle and the radio successfully, the led will light up solid.
  • Page 4 If during the auto-detect sequence there was no long Green led flash, just short ones, the ASWC-1 was not connected to the correct wire in the vehicle, or the incorrect wire was used on the ASWC-1. Double check connections and the vehicle information sheet to verify that you have the correct wires connected.
  • Page 5 XITE * Note: If the ASWC-1 flashes Red 7 times and you do not have an Alpine radio connected to it that means that the ASWC-1 did not see any radio connected. Verify the...

Table of Contents