Fm Radio Operation (Fm) - Silvercrest SBDB 5 A1 Operating Instructions And Safety Instructions

FM radio operation (FM)

Automatic station scan (AMS)
♦ This device must be switched on. If necessary, briefly press the
to switch on the device.
If necessary, briefly press the SOURCE /
♦
until FM radio mode and the frequency display in Mhz is shown on the
display
♦ Briefly press the
station scan. The display
The station scan stops at the next station with a sufficiently strong signal.
Storing stations automatically
The automatic station scan with station saving scans the entire frequency band
once and automatically saves the FM radio stations found as an FM station list.
♦ Press the
the automatic station scan with station saving. The display
the message Scanning... FM and the number of found stations. The scan
progress is displayed as a progress bar. The FM radio stations found are
automatically stored in the station list on order of increasing frequency.
When the scan is finished, the first station in the station list is automatically
played back.
NOTE
► An automatic station scan with station saving may overwrite an existing
station list.
Selecting stations
Press PRESET
♦
Press TUNE+
♦
station list.
SBDB 5 A1
1.
ENTER / SCAN button
1
now shows the message Scanning....
ENTER / SCAN button
7
for about 2 seconds to call up the FM station list.
9 8
or TUNE−
4
button
3
to start the automatic
3
for approx. 2 seconds to start
to select an FM radio station from the
GB │ IE │ NI
2
button
several times
1
now shows
│ 15 ■