Resetting The Grease Filter Operating Hours Counter - Miele DA 5000 D Operating And Installation Instructions

Cleaning the grease filters in the
dishwasher
^ Place the filters with the short side
upright in the lower basket, and wash
on a 65°C programme using a mild
dishwasher detergent, ensuring the
spray arm is not obstructed.
Avoid alkaline dishwasher detergents
(with a pH value higher than 7).
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
^ After cleaning, leave the filters to dry
on an absorbent surface before
replacing them.
^ When removing the filters for
cleaning, also clean off any residues
of oil or fat from the now accessible
housing to prevent the risk of these
catching fire.
Cleaning and care
^ When the cooker hood is operating,
grease residues are deposited in the
grooves on either side of the canopy.
Clean these grooves and the grease
filter holders every time the grease
filters are removed.
^ Replace the grease filters.
^ Then touch any of the "1" to "4"
sensors. The fan will then switch
back on.
Resetting the grease filter operating
hours counter
After cleaning, the operating hours
counter needs to be reset.
^ Touch the s sensor to switch the fan
on.
^ Touch the l sensor for approx.
3 seconds until only the "1" sensor is
flashing.
The l sensor light will go out.
If the grease filters are cleaned before
the operating hours counter has
reached its maximum,
^ touch the l sensor for approx.
6 seconds until only the "1" sensor is
flashing.
19