Miele DA 5000 D Operating And Installation Instructions
Hide thumbs
Also See for DA 5000 D:
- Operating and installation manual (32 pages) ,
- Operating and installation instructions (32 pages) ,
- Product dimensions (2 pages)
Table of Contents
Related Manuals for Miele DA 5000 D
Summary of Contents for Miele DA 5000 D
- Page 1 Operating and installation instructions Cooker hood DA 5000 D en - GB To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Contents Caring for the environment ......... . 3 Warning and Safety instructions . -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. -
Page 4: Warning And Safety Instructions
Warning and Safety instructions This appliance is not intended for This appliance complies with all use by persons (including children) relevant local and national safety with reduced physical, sensory or requirements. Inappropriate use mental capabilities, or lack of can, however, lead to personal injury experience or knowledge, unless they and damage to property. - Page 5 Installation, maintenance and appliance could be damaged. Consult repairs may only be carried out by a qualified electrician if in any doubt. a Miele authorised person in The electrical safety of this accordance with current national and appliance can only be guaranteed local safety regulations.
- Page 6 Warning and Safety instructions Do not connect the appliance to Using at the same time as other the mains electricity supply by a heating appliances that depend on multi-socket unit or an extension lead. the air from the room These do not guarantee the required safety of the appliance (e.g.
- Page 7 The Miele DSM 400 control module be switched on when the heating offers the possibility of combining other appliance is switched off or vice versa.
- Page 8 Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you Never use an open flame beneath will avoid the risk of grease and dirt the cooker hood. To avoid the getting into the appliance and danger of fire, do not flambé...
- Page 9 All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
-
Page 10: Guide To The Appliance
Guide to the appliance... - Page 11 Guide to the appliance a Cover plate h Touch control for the feature lighting b Tower i Touch control for hob lighting c Canopy This control switches the lighting on The canopy opens as soon as the fan is and off, and is also a dimmer switch. switched on.
-
Page 12: Mode Of Operation
Mode of operation The cooker hood works with . . . air extraction: The air is drawn in and cleaned by the grease filters and directed outside. The cooker hood is fitted with a non-return flap which is closed when the cooker hood is switched off. -
Page 13: Operation
If the cooker hood has been – the "1" sensor and connected to a window contact switch via the Miele DSM 400 control – the n sensor again. module, then the fan cannot be The sensors for fan power levels 1 and switched on if the window is shut. -
Page 14: Run-On Option "5M15
Operation Run-on option "5 15" Hob lighting It is advisable to leave the fan running The hob lighting can be switched on for a few minutes after cooking has and off independently of the fan. finished to neutralise any lingering odours in the air. -
Page 15: Feature Lighting
Operation Feature lighting Reading the grease filter operating hours counter The feature lighting can be switched on and off by touching the" "sensor. To check the percentage of time set already used: ^ Touch the s sensor to switch the fan Safety cut-out ^ Touch and hold the l sensor. -
Page 16: Sensor Control Audible Tones
Operation ^ Touch the "1" sensor to select a Altering the grease filter operating shorter time and the "4" sensor to hours counter select a longer time, until the time You can set the operating hours required has been set. counter to suit the type of cooking you ^ Confirm your selection by touching the l sensor. -
Page 17: Cleaning And Care
Housing Important for appliances with stainless steel surfaces General notes ^ Stainless steel surfaces can be cleaned using the Miele E-Cloth or The surfaces are susceptible to with a suitable, non-abrasive, scratches and abrasions. Please proprietary cleaning agent, following observe the following cleaning the manufacturer's instructions on the instructions. -
Page 18: Grease Filters
Cleaning and care Grease filters To avoid damaging the filters or the The re-usable metal grease filters in the hob below, make sure you hold the appliance remove solid particles filters securely at all times when (grease, dust, etc.) from the kitchen handling them. -
Page 19: Resetting The Grease Filter Operating Hours Counter
Cleaning and care Cleaning the grease filters in the dishwasher ^ Place the filters with the short side upright in the lower basket, and wash on a 65°C programme using a mild dishwasher detergent, ensuring the spray arm is not obstructed. Avoid alkaline dishwasher detergents (with a pH value higher than 7). -
Page 20: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp To change the lamps, the canopy needs to be open. ^ Touch the s sensor. The fan will start running at power level 2, and the canopy will open. ^ Touch the "2" sensor for approx. 5 seconds, until the fan switches off. -
Page 21: Changing A Fluorescent Tube
Cleaning and care Changing a fluorescent tube ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the isolator, or – the screw-out fuse is removed (in countries where this is applicable), or –... -
Page 22: Appliance Dimensions
Appliance dimensions Safety distance between hob and cooker hood The minimum safety distances between the top of a cooker or hob and the bottom of the cooker hood are as follows, unless a greater distance is specified by the manufacturer of your cooking appliance: 550 mm above electric hobs and... -
Page 23: Installation
Installation Before installation, it is important to The screws and plugs are for use in read the information given on the concrete ceilings only. following pages as well as the For other types of construction, "Appliance dimensions" and the alternative suitable fixings will be "Warning and Safety instructions"... -
Page 24: Connection For Air Extraction
Connection for air extraction – When ducting is horizontal it must be Important: To avoid the danger of laid to slope away at at least 1 cm toxic fumes, please observe the per metre to ensure no condensate Warning and Safety instructions. drains into the appliance. - Page 25 Connection for air extraction For exhaust ducting with a diameter of 200 mm, the following accessories are required: – Exhaust grille DFG 200, for mounting on the external wall. *Lead flashing – Roof ducting DDF 200, for mounting on a sloping tiled roof. –...
-
Page 26: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to install and local safety regulations a residual current device (RCD) with a... -
Page 27: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 control module can If the control module is be used to combine the cooker hood disconnected in order to operate the with other components. cooker hood without the window It enables the following: contact switch (e.g. -
Page 28: Connection To A Light Switch
Operation with Control module DSM 400 Connection to a light switch The control module can be used to switch on the hob lighting on the cooker hood and also to dim it, depending on model, via a light switch in the house. The feature lighting cannot be operated via the control module. -
Page 29: After Sales Service
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance. -
Page 30: Technical Data
Technical data Total connected load..632 W – Fan motor ....500 W – Canopy mechanism ... 4 W –... - Page 32 Alteration rights reserved / 1707 M.-Nr. 07 087 760 / 00...