Table of Contents
Advertisement
Main axis not at 100 degrees
When your main access is not at 100 degrees, an error message will be displayed on your screen.
1. Click OK.
2.
Press the 100-degree button.
If you are still receiving the error message,
1. Clear the message from the screen.
2. Turn off the embroidery machine.
3. Rotate the degree knob in the back of the embroidery machine to 100 degrees. See
Figure 108.
4. Press the 100-degree button.
NOTE: If you are still experiencing issues, please contact your local dealer where you made your initial purchase.
This section intentionally left blank.
Degree Knob
Ricoma® embroidery machine EM1010 – Operations manual
Figure 108
Page 97
© Ricoma® All rights reserved
- Quick Links:
- Touch Screen
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the EM-1010 and is the answer not in the manual?
Questions and answers
test embroidery machine to see if the hrad
To test if the Ricoma EM-1010 embroidery machine's head is functioning properly, follow these steps:
1. Check Thread Path – Ensure the thread follows the correct path from the thread cone to the needle.
2. Inspect Needles – Verify that the needles are not defective and are inserted properly.
3. Check Thread Tension – Ensure the tension is not too tight or too loose to prevent thread breaks or looping.
4. Examine Hook Timing – If thread breaks occur frequently on all needles, adjust the hook timing.
5. Verify Bobbin Installation – Ensure the bobbin is installed correctly and the supply is adequate.
6. Clean Bobbin Case – Remove any lint or dirt buildup from the bobbin case.
7. Check Thread Trimmer – Ensure the thread trimmer knife is fully retracted.
8. Perform a Manual Trim – If no thread break is apparent, manually trim the thread.
9. Rotate Degree Knob – Turn the degree knob at the back of the machine to 100 degrees and press the 100-degree button.
If issues persist, contact the dealer where the machine was purchased.
This answer is automatically generated
test embroidery machine check head will move
To test if the Ricoma EM-1010 embroidery machine head will move, perform an embroidery design tracing:
1. Press the trace design icon.
- The embroidery hoop may automatically move within the maximum design range.
- If the needle position is incorrect, the machine will adjust itself.
2. A message stating, “Enter embroidery status?” will display.
3. Press OK.
This process verifies whether the embroidery machine head moves correctly.
This answer is automatically generated