Table of Contents
Advertisement
At Ricoma®, we are dedicated to providing the best customer service, support and training. Our trained and
certified technical staff is ready to help you. Whether you are a beginner or veteran embroiderer, our professional
instructors have years of experience in the industry and can help you understand and operate your embroidery
machine at your own pace and schedule.
If you should have any questions regarding your embroidery machine or training, please contact your local
Ricoma® dealer to schedule an appointment.
Please contact your local Ricoma© dealer first.
To locate your local dealer, contact customer service.
For customers located in North America, Central America, South America and the Caribbean, please
visit Ricoma.us.
Our customer service & training department is located at the home office in Miami, FL (U.S.A.).
Telephone: 305-418-4421 (Monday through Friday; 9 a.m. to 5:30 p.m. EST)
Toll-free number: 1-888-292-6282 (Monday through Friday; 9 a.m. to 5:30 p.m. EST)
Email:
service@ricoma.us
Fax: 305-418-5036 or 305-418-4463
For customers located in Asia, Europe, Africa, the Middle East and Oceania, please contact your local distributor
first or visit Ricoma.cn.
Our customer service department is located in Shenzhen, China.
Telephone: +86-755-2585 7772 (Monday through Friday, 8 a.m. to 5:30 p.m., China time)
Email:
service@ricoma.cn
Fax: +86-755-2585 7773
Ricoma® embroidery machine EM1010 – Operations manual
Page 10
© Ricoma® All rights reserved
- Quick Links:
- Touch Screen
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the EM-1010 and is the answer not in the manual?
Questions and answers
test embroidery machine to see if the hrad
To test if the Ricoma EM-1010 embroidery machine's head is functioning properly, follow these steps:
1. Check Thread Path – Ensure the thread follows the correct path from the thread cone to the needle.
2. Inspect Needles – Verify that the needles are not defective and are inserted properly.
3. Check Thread Tension – Ensure the tension is not too tight or too loose to prevent thread breaks or looping.
4. Examine Hook Timing – If thread breaks occur frequently on all needles, adjust the hook timing.
5. Verify Bobbin Installation – Ensure the bobbin is installed correctly and the supply is adequate.
6. Clean Bobbin Case – Remove any lint or dirt buildup from the bobbin case.
7. Check Thread Trimmer – Ensure the thread trimmer knife is fully retracted.
8. Perform a Manual Trim – If no thread break is apparent, manually trim the thread.
9. Rotate Degree Knob – Turn the degree knob at the back of the machine to 100 degrees and press the 100-degree button.
If issues persist, contact the dealer where the machine was purchased.
This answer is automatically generated
test embroidery machine check head will move
To test if the Ricoma EM-1010 embroidery machine head will move, perform an embroidery design tracing:
1. Press the trace design icon.
- The embroidery hoop may automatically move within the maximum design range.
- If the needle position is incorrect, the machine will adjust itself.
2. A message stating, “Enter embroidery status?” will display.
3. Press OK.
This process verifies whether the embroidery machine head moves correctly.
This answer is automatically generated