Adjusting The Left Hand Side; Moving The Blade Forward; Moving The Blade Rearward - Woodland Mills HM122 Owner's Manual

Adjusting The Left Hand Side

To adjust the left side of the sawmill, again start by taking the tension off of the blade by turning the
"T" handle one turn in the counter-clockwise direction. Using an 18mm wrench, loosen the "vertical
nut" a ½ turn. Next, loosen the "vertical bolt" a ½ turn. This will take the clamping force off of the
band wheel shaft caused by these two bolts and allow it to move freely in the following steps.

Moving the Blade Forward

Using a wrench, hold the "horizontal bolt" stationary with a wrench and turn the "horizontal inside
nut" counter-clockwise a ½ turn. Still holding the "horizontal bolt" stationary, turn the "horizontal
outside nut" clockwise a ½ turn. This has now shifted the "horizontal bolt" and band wheel shaft,
causing the blade to track more forward.

Moving the Blade Rearward

Using a wrench, hold the "horizontal bolt" stationary with a wrench and turn the "horizontal
outside nut" counter-clockwise a ½ turn. Still holding the "horizontal bolt" stationary, turn the
"horizontal inside nut" clockwise a ½ turn. This step has now shifted the "horizontal bolt" and
band wheel shaft, causing the blade to track more rearward.
Tighten the vertical bolts, then nuts to clamp the band wheel shaft back into vertical position.
Vertical Bolt
Horizontal
Bolt
Horizontal
Outside Nut
Page
Vertical Nut
Horizontal
Inside Nut
34 of 49