Clear Ip Arp - Cisco Nexus 3548 Command Reference Manual

Chapter Unicast Routing Commands

clear ip arp

To clear the Address Resolution Protocol (ARP) information, use the clear ip arp command.
Syntax Description ip-addr
ethernet
slot/port
sub_if
loopback
if_number
port-channel
number
sub_if-number
force-delete
statistics
vrf vrf-name
all
default
management
Command Default
None
Command Modes Any command mode
Command History Release
5.0(3)A1(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to clear the ARP table:
switch# clear ip arp
OL-27852-01
clear ip arp [ip-addr | ethernet slot/port[.sub_if] | loopback if_number | port-channel
number[.sub_if_number]] [force-delete | statistics] [vrf vrf-name | all | default | management]
(Optional) IPv4 source address. The format is x.x.x.x.
(Optional) Specifies the Ethernet interface and the slot number and port number. The
slot number is from 1 to 255, and the port number is from 1 to 128.
(Optional) Specifies the Ethernet subinterface port number. The range is from 1 to
48.
(Optional) Specifies the loopback interface. The loopback interface number is from
0 to 1023.
(Optional) Specifies the EtherChannel interface and EtherChannel number. The
range is from 1 to 4096.
(Optional) Subinterface number. The range is from 1 to 4093.
(Optional) Clears the entries from the ARP table without a refresh.
(Optional) Clears ARP statistics.
(Optional) Specifies the virtual routing and forwarding (VRF) context name. The
name can be any case-sensitive, alphanumeric string up to 32 characters.
(Optional) Clears the ARP information from all VRF entries.
(Optional) Clears the ARP information from the default VRF.
(Optional) Clears the ARP information from the management VRF.
Modification
This command was introduced.
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
clear ip arp
69