Freeze Protection - Viking spas Viking 1P User Manual

OPERATION
INSTRUCTIONS VS502
(Royale ETS, Regal ETS, Legacy, Legend, Heritage & Tradition)
PUMP 1
Press the "Pump 1" button once to activate the low
speed of the pri-mary pump and again for the high
speed. Press the "Pump 1" button again to turn off
the pump. If left running, the pump's high speed
will automatically turn off after 15 minutes. The low
speed of the pump runs when the secondary pump
is on. It may also activate for at least 2 minutes
every 30 minutes to detect the spa temperature
and then to heat to the set temperature, if needed,
depending upon mode. When the low speed turns
on automatically, it cannot be deactivated from the
panel, however, the high speed may be started.
PUMP 2
This button is used to turn the secondary pump on
and off. If left on, the pump automatically turns off
after 15 minutes.
LIGHT
Press the "Light" button to turn the light on and
off. If left on, the light automatically turns off after
4 hours. In spas equipped with LED light, press
the light button consecutively to change the color
sequenc-ing.
MODE
The mode is changed by pressing the "Temp"
button, then pressing the "Light" button.
Standard Mode is programmed to maintain the
desired temperature. Note that the last measured
spa temperature displayed is current only when the
pump has been running for at least 2 minutes. "St"
will be displayed momentarily when you switch into
Standard mode.
13
Economy Mode heats the spa to the set
temperature only during filter cycles. "Ec" will
display solid when temperature is not current, and
will alternate with temperature when temperature is
current.
Sleep Mode heats the spa to within 20°F/10°C
of the set temperature only during filter cycles.
"SL" will display solid when
current, and will alternate with temperature when
temperature is current.
Preset filter cycles The first filter cycle begins 6
minutes after the spa is energized. The second
filter cycle begins 12 hours later. Filter duration
is programmable at the topside control for 2, 4,
6, 8 hours, or 12 hours for continuous filtration,
(indicated by "FC"). The default filter time is 2
hours. To program, press "Temp", then
"Jets". Press "Temp" to adjust. Press "Jets" to exit
programming.
NOTE: The Secondary Pump purges for 30 seconds at
the beginning of each filter cycle. The low speed of
the primary pump runs during fil-tration and the
ozonator (if installed) will be enabled.

FREEZE PROTECTION

NOTE: For all other diagnostic messages, please refer to
the Balboa Operation Guide that came with your spa.
Warning! / Shock Hazard! / No User Serviceable
Parts. Do not attempt service of this control
system. Contact your dealer or service
organization for assistance. Follow all owner's
manual power connection instruc-tions.
Installation must be performed by a licensed elec-
trician and all grounding connections must be
properly installed.
temperature is not