Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Indesit BIWDIL7125
Summary of Contents for Indesit BIWDIL7125
- Page 1 User Manual www.indesit.com/register...
- Page 2 Quick Guide THANK YOU FOR BUYING A INDESIT PRODUCT Before using the appliance carefully read the Safety Instruction. In order to receive a more complete assistance, Before using the machine, it is imperative that the transport bolts are removed. please register your product on For more detailed instructions on how to remove them, see the Installation Guide.
-
Page 3: First Time Use
WASH CYCLES WASH CYCLE PHASE INDICATOR LIGHTS Follow the instructions on the symbols of the garment’s wash Once the desired wash cycle has been selected and has begun, the care label. The value indicated in the symbol is the maximum indicator lights switch on one-by-one to indicate which phase of the cycle recommended temperature for washing the garment. -
Page 4: Tips And Suggestions
FUNCTIONS PAUSE button. If the DOOR LOCKED symbol is off, the door may be opened only during the washing phase. Press the START/PAUSE button - If the selected option is not compatible with the set wash cycle, the again to restart the wash cycle from the point at which it was interrupted. indicator light will flash and the option will not be activated. -
Page 5: Troubleshooting
TROUBLESHOOTING The washing machine may occasionally fail to work. Before contacting the Technical Assistance Service, make sure that the problem cannot be easily solved using the following list. Anomalies Possible causes / Solution The appliance is not plugged into the socket, or not sufficiently to make contact. The washing machine does not start. -
Page 6: Cleaning And Maintenance
CLEANING & MAINTENANCE For any cleaning and maintenance, switch off and unplug the washing machine. Do not use flammable fluids to clean the washing machine. CLEANING THE OUTSIDE OF THE WASHING MACHINE Do not use glass or general purpose cleaners, scouring Use a soft damp cloth to clean the outer parts of the washing powder or similar to clean the control panel –... -
Page 7: Cleaning The Detergent Dispenser
CLEANING THE DETERGENT DISPENSER Remove the dispenser by raising it and pulling it out (see figure). Wash it under running water; this operation should be repeated frequently. CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER Switch off and unplug the washing machine before cleaning the water filter or draining residual water. If you used a hot wash programme, wait until the water has cooled down before draining any water. -
Page 8: Transport And Handling
OCCURS, GET IN TOUCH WITH THE NEAREST rating plate). AFTER-SALES SERVICE To receive assistance, call the number shown on the warranty booklet or follow the instructions on the website http://docs.indesit.eu When contacting our Client After sales service, always specify: • your full address; •... - Page 9 10 mm - 0,39 inch 150 ml 100 ml 50 ml 2 cm - 0,7 inch...
- Page 10 max 0,5 cm max 0,2 inch max 100 cm 39 inch max 100 cm min 65 cm 39 inch 25 inch min 65 cm 25 inch max 100 cm 39 inch min 65 cm 25 inch...
-
Page 11: Safety Instructions
SAFETY INSTRUCTIONS IMPORTANT TO BE READ AND OBSERVE used as specified by the fabric softener Before using the appliance, read these safety in- instructions. structions. Keep them nearby for future reference. The final part of a tumble dryer cycle occurs These instructions and the appliance itself provide without heat (cool down cycle) to ensure that the important safety warnings, to be observed at all ti-... - Page 12 Do not install your appliance where it may be Do not use extension leads, multiple sockets or exposed to extreme conditions, such as: poor adapters. The electrical components must not be ventilation, temperatures below 5 °C or above 35 °C. accessible to the user after installation.
-
Page 13: Instructions For The Fitter
INSTRUCTIONS FOR THE FITTER Door Mounting Accessories (Fig. 1-2-3-4-5). Mounting the wooden panel onto the door and inserting the machine into cabinets: In the case where the machine must be shipped for final installation after the wooden panel has been mounted, we suggest leaving it in its original packaging. - Page 14 Using the Drilling Template. - To trace the positions of the holes on the left- hand side of the panel, align the drilling template to the top left side of the panel using the lines traced on the extremities as a reference. - To trace the positions of the holes on the right- hand side of the panel, align the drilling template to the top right side of the panel.
Need help?
Do you have a question about the BIWDIL7125 and is the answer not in the manual?
Questions and answers