Advertisement
5.1.2
Setup
Use the mouse to fill in the boxes on the forms, which are later printed out. These forms provide the appearance of
"virtual paper"; see also Chapter
5.1.2.1
Parameter set
5.1.2.1.1 Open parameter set
Opening a parameter set: Select the menu item Parameter-set / Open or click on the Open symbol
parameter set...
21
with a right click to the device at the Device definition.
A selection dialog appears.
By default, the parameter sets already defined are displayed for the branch circuit assigned to this device. (For this
reason, prior to this action the measurement must be assigned in the topology.) In the dialog shown, however, you
can also view and open parameter sets of other branches. After opening, the devices for which the parameter sets
were defined are activated. By saving these as templates, however, you can also assign them to another device.
Branch circuit 1
- ParameterSet11 (for device a)
- ParameterSet12 (for device a)
- ..
Branch circuit 2
- ParameterSet 21 (for device b)
- ParameterSet 22 (for device b)
- ..
Selected device: "Device a"
1. "Load a parameter set.." from "ParameterSet11"
2. The active device is "Device a"
Or:
1. "Load a parameter set.." from "ParameterSet21"
2. The active device is "Device b"
3. all further actions are performed with Device b.
Forms
.
184
Operation modes and settings
Power Quality Recorder SICAM Q80 7KG8080, System manual
E50417-H1076-C420-A2, Release 12.01.2015
29
or select
Load
Advertisement
