Whirlpool CAM2762KQ Installation Instructions

For debitek slim reader

Download this manual

WHIRLPOOL CAM2762KQ WASHER

Remove the two screws on either side of the machine backsplash

(Fig. 1) and raise the backsplash to gain access to the wiring har-

ness. The access cover on the meter housing should also be re-

moved.

Fig. 2

Locate the beige jumper wire attached to the

bottom plug (Fig. 3). The end of this wire may be

taped to the harness. If the wire is not already

connected to the upper plug (black), the terminal

on this wire must be installed in the upper plug in

order for the machine to operate.

INSTALLATION INSTRUCTIONS

FOR DEBITEK SLIM READER

Fig. 1

Locate the two mounting screws for the

machine timer inside the meter housing (Fig.

2). Loosen the screws. They do not need to

be completely removed. Lift up on the timer

assembly and remove it from the meter

housing. It may be necessary to remove the

two harness plugs on the back of the timer in

order to accomplish this step. Press in on the

clips on either side of the timer plugs to

release them and carefully detach them from

the timer.

Fig. 3

Page 1 WHIRLPOOL CAM2762KQ WASHER INSTALLATION INSTRUCTIONS FOR DEBITEK SLIM READER Remove the two screws on either side of the machine backsplash (Fig. 1) and raise the backsplash to gain access to the wiring har- ness. The access cover on the meter housing should also be re- moved.
Page 2 Looking at the rear of the upper plug, the connector on the beige jumper should be inserted into the empty slot located in the second position from the left on the top row. This position should have a black wire with a white stripe directly below it.
Page 3 Route the loose ends of the reader harness through the hole in the side of the backsplash area into the meter housing and attach the machine’s feature connector plug (Fig.7) to the appropriate connec- tor on the harness. Fig. 7 Pull the end of the reader cable with the black Molex connector through the coin slide opening (Fig.