Troubleshooting - solarwatt MYRESERVE User Manual

Troubleshooting

The MyReserve's Status LED will light up red or red/yel-
low to indicate any malfunctions. Under certain circum-
stances (and after consulting with your installer), some
error codes can be resolved by simply restarting the
system manually. To do this, interrupt the power supply
NOTE NOTE NOTE NOTE
Due to the interaction of the entire system, several error codes may also be displayed simultaneously. Accor-
dingly, the error code then consists of several error messages together.
NOTE NOTE NOTE NOTE
After a restart of MyReserve, an initialization with calibration and check of the start conditions takes place (a
PV-surplus must be measured once).
Unloading will not occur until the following day after MyReserve has detected a minimum surplus of PV energy.
Subject to change | © 2018 SOLARWATT GmbH | AZ-TM-PME-0940 | Rev 004 | Version: 09/2018
to the MyReserve by unplugging the power supply from
MyReserve Command , wait 60 seconds, then switch the
power on again.
This illustration shows the various error codes and what
they mean.
EN
Page 19