Qt/Dqt Encode; Channel Name; Multi-Table; W/N - Kenwood TKR-750 Programming Reference Manual

6.1.4

QT/DQT Encode

It can configure the signalling for the transmission. You
can select the QT tone or DQT code from the dropdown
list. You can also directly enter the QT tone and the DQT
code.
# Selecting the QT/DQT Encode Code from the
Dropdown list:
QT
Range DQT Normal
DQT Inverse
Default None
# Directly Entering the QT/DQT Encode Code:
QT
Default DQT Normal
DQT Inverse
QT
In steps of
DQT
Default None
Note:
! You can use numbers, "D", "N", "I", ".", and "," for the 5 digits of
the QT/DQT Encode code.
! When entering only numbers, the code is automatically
configured as the QT Tone.
! When entering "D" as the first character of the code, the code is
automatically configured as the DQT code.
! When entering the value, which is out of the range, it will be
automatically replaced with the highest value or the lowest value
in the range.
6.1.5

Channel Name

It can configure the name of the channel. The configured
Channel Name appears on the Channel/Status display
when selecting the channel with the PF key. (Refer to
FUNC 1.6 Display.)
2 digits
Range 0 ~ 9, A, b, c, d, E, F, G, H, i, J, L, n, o, P, q, r, S,
t, U, y, -, =, _
Default Channel Number (1 - 16)
Note: The TKR-750/850/751/851 may not properly recognize the
entered characters when entering the reserved characters,
such as "PG", "E1","E2", "E3", "E4". Do not use the reserved
characters for the channel name.
Version: 1.01
67.0 - 250.3 Hz
D023N - D754N
D023I - D754I
67.0 - 254.1 Hz
D000N - D777N
D000I - D777I
0.1 Hz
1
Field Programming Reference (FPRG)

6.1.6 Multi-table

It can select whether or not the
for a call with the QT/DQT Decode code configured to
each channel and the QT/DQT Decode code configured
in the Multi-table. This function is available only when the
QT/DQT Decode code is configured on the "Channel
Information" window and the Decode code is configured
on the Multi-table. (Refer to 6.11 Multi-table Window.)
Range Yes, No
Default No
Note:
! The signalling encoded when the PTT switch is pressed depend
on configuration of the "Encode Tone in Multiple" of the "Channel
Edit" window. (Refer to 6.2.7 Encode Tone in Multiple.)
! Do not configure the same QT/DQT Decode data in the Multi-
table. When one or more same QT/DQT Decode data are
configured in the Multi-table and the QT/DQT Encode data are
different, the repeater cannot specify the QT/DQT Encode data
to be transmitted.
6.1.7

W/N

It can configure the transmission bandwidth for each
channel. Select the bandwidth from Wide and Narrow
from the dropdown list. (Refer to FUNC 1.4 Transmission
Bandwidth.)
Range Wide, Narrow
Default Wide
6 EDIT MENU
waits
TKR-750/850/751/851
18