Chapter 4. User Programming
4.1 Introduction
IMPORTANT:
The oxy.IQ Service menu is for use by qualified service
personnel only and requires a special passcode for
access. That menu is not discussed in this chapter.
This chapter provides instructions for programming all of the oxy.IQ
menu options available to the user, which can be accessed without
the use of a passcode. These menu options are found in the following
Main Menu submenus:
•
Calibration Menu
•
Display Menu
•
Output Menu
While programming these menus, refer to the menu map in Figure 16
on page 46.
Note:
The menu options for initial setup are described in Chapter 3,
Initial Setup & Operation, and are only referenced in this
chapter.
4.2 The Calibration Menu
Proceed to the appropriate section to program the desired menu
option.
4.2.1 Air
See "Air Calibration" on page 17.
4.2.2 Span Gas
See "Span Gas Calibration" on page 19.
oxy.IQ User's Manual
Chapter 4. User Programming
21