Setting The Cool/Heat Selection Eligibility; Setting Changes; Selection Settings - Daikin BRC1E63 Operation Manual

Setting the Cool/Heat Selection Eligibility

Setting Changes

1
Cool
Set to
Cool
Set to

Selection Settings

2
Cool
Set to
Cool
Set to
Refer to "Cool/Heat Selection Eligibility" on page 19 for an explanation of the
cool/heat selection eligibility.
• Press Mode Selector button on the remote controller
that has cool/heat selection eligibility for at least
28
4 seconds. (During backlight lit)
°C
A remote controller will not display
" " (Changeover Under Control) if a cool/heat
selection eligibility is granted to the remote
controller.
• The icon "
connected to the same outdoor unit or BS unit will start blinking.
28
°C
* Vent mode setting changes are possible regardless of the cool/
heat selection eligibility.
* If a cool/heat selection eligibility is set in the "Cool/Heat selector"
( ), all the remote controllers will display the icon "
case, no cool/heat selection eligibility can be set in the remote
controllers.
Refer to the Operation Manual attached to the outdoor unit for
the details of the "Cool/Heat selector".
• Set a cool/heat selection elig bility as follows.
The icon "
• Press Mode Selector button on the remote
controller for which the selection eligibility to be
28
set.
°C
Then the cool/heat selection eligibility will be set
and the icon "
The icon "
controllers.
28
°C
" on each remote controller of indoor units
" (Changeover Under Control) will blink on all remote
" will disappear.
" will appear on the other remote
(VRV only)
" . In this
18